| dc.creator |
Nieckele Angela Ourivio |
|
| dc.creator |
Saboya Francisco Eduardo Mourão |
|
| dc.date |
2000 |
|
| dc.date.accessioned |
2013-05-30T11:24:51Z |
|
| dc.date.available |
2013-05-30T11:24:51Z |
|
| dc.date.issued |
2013-05-30 |
|
| dc.identifier |
http://www.scielo.br/scielo.php?script=sci_arttext&pid=S0100-73862000000100010 |
|
| dc.identifier |
http://www.doaj.org/doaj?func=openurl&genre=article&issn=01007386&date=2000&volume=22&issue=1&spage=119 |
|
| dc.identifier.uri |
http://koha.mediu.edu.my:8181/jspui/handle/123456789/4579 |
|
| dc.description |
Experiments were performed to determine average heat transfer coefficients and friction factors for turbulent flow through annular ducts with pin fins. The measurements were carried out by means of a double-pipe heat exchanger. The total number of pins attached to the inner wall of the annular region was 560. The working fluids were air, flowing in the annular channel, and water through the inner circular tube. The average heat transfer coefficients of the pinned air-side were obtained from the experimental determination of the overall heat transfer coefficients of the heat exchanger and from the knowledge of the average heat transfer coefficients of the circular pipe (water-side), which could be found in the pertinent literature. To attain fully developed conditions, the heat exchanger was built with additional lengths before and after the test section. The inner circular duct of the heat exchanger and the pin fins were made of brass. Due to the high thermal conductivity of the brass, the small tube thickness and water temperature variation, the surface of the internal tube was practically isothermal. The external tube was made of an industrial plastic which was insulated from the environment by means of a glass wool batt. In this manner, the outer surface of the annular channel can be considered adiabatic. The results are presented in dimensionless forms, in terms of average Nusselt numbers and friction factors as functions of the flow Reynolds number, ranging from 13,000 to 80,000. The pin fin efficiency, which depends on the heat transfer coefficient, is also determined as a function of dimensionless parameters. A comparison of the present results with those for smooth sections (without pins) is also presented. The purpose of such a comparison is to study the influence of the presence of the pins on the pressure drop and heat transfer rate. |
|
| dc.publisher |
The Brazilian Society of Mechanical Sciences |
|
| dc.source |
Journal of the Brazilian Society of Mechanical Sciences |
|
| dc.subject |
annular regions |
|
| dc.subject |
heat transfer coefficients |
|
| dc.subject |
pressure drop |
|
| dc.subject |
pin fins |
|
| dc.subject |
turbulent flow |
|
| dc.title |
Turbulent heat transfer and pressure drop in pinned annular regions |
|